RPM Control Company EDRI - J1939

Email: rpmcontrol@rpmcontrol.com

EDRI - J1939
	This product is able to control the engine RPM, either a Set RPM(S)* or a variable RPM (Increase/Decrease). The EDR I – J1939 can be switched on by either a 12 volts or by ground activation. It is connected to the engine ECM through the high speed J-1939 data port connection that is usually already wired. When connected to the engine ECM and is powered up it will take 12v inputs into it and control the engine RPM depending on how the engine ECM was programmed. This product also has two relays on the board that can be used control starting or stopping of the engine or for other systems that need to be supply power or ground. The first relay
output is a 12v N/O only and the second relay allows you to configure the common for either a ground or a positive which will send a output out the N/C and the N/O output of the relay. The outputs are rated for a max output of 7.5 amps. The EDR I –J1939 is roughly 5” X 5” 1 1/2” with a 12 pin connector. The following is the description of the 12 Pin connector connections.
Pin# 1 - Chassis Ground Pin# 2 - Relay # 1 Com Pin# 3 - Relay # 1 (N/O or N/C) Determine by cutting a Jumper wire on Circuit Board Pin# 4 – Relay # 1 Coil (12v Active) Pin# 5 – Power (12 V Key Switch) Pin# 6 – Relay # 2 N/O (12V) Pin#7 – CAN High (J1939 +) Pin#8 – CAN Low (J1939 -) Pin#9 – RPM On/Off Input (12v Active) Pin#10 – Set Input (Increase) (12v Active) Pin#11 – Resume Input (Decrease) (12v Active) Pin#12 – Relay # 2 Coil (12v Active) also will active RPM A * Some engines allow more that one Set RPM configurations This product sells for: OEM Price: $275.00 CDN / $275.00 US List Price: $357.50 CDN / $357.50 US

The New Way to Control RPM

HOME | ABOUT | CONTACT | ORDER
CRANE INSTALLATIONS | UTILITY INSTALLATIONS | STONE SPREADERS | MISC. INSTALLATIONS
OTHER PRODUCT DESCRIPTIONS | INSTALLATION INSTRUCTION MANUALS | TESTIMONIALS
FULL PRODUCT LISTING | BROCHURES | RPM CONTROL NEWS

© RPMControl, 2003