- Up to 8 Wireless Inputs & Up to 8 Hard Wired Inputs
- Smart Engine Start/Stop - One Input Control
- Set RPM/E-Pump Control - One Input Control
- 3 Programable Set Speeds & Variable RPM Increase/Decrease
- Foot/Hand Throttle Control
- Auto Neutral
- Cab Throttle Inhibit
- On Board Programming
- LED Light Diagnosing
- Plug and Play Harnesses Available
This is a replacement for the previous TESS203/303 systems. It is the same size and has the same 10 Pin connector as the TESS203/303. It will controls the engines Starting and Stopping, set RPM and E-pump. It will not work with the previous TESS204 transmitter, you need to use either the TESS504, 433T4 or 433T8 transmitter. Programming the transmitters to connect to the receiver is made easy and is done on the PCB. The transmitter have a range of approximately 200 feet depending on any physical obstruction that might impede the signal reception.
This is a 2 Button FOB transmitter that is used with the EDRJW100. With this FOB you can Start the engine and stop the engine with one button, the other button will allow you to work the set RPM when the engine is running and when the engine is not running, it will allow you to turn on the E-Pump. This FOB will transmit up to 750 feet (230 m) and it measures 2.23" X 1.37" roughly.
This is a 4 Button FOB transmitter that can be used with the EDRJW100 & TESS604 receivers. This FOB has a function for each button. The four functions for this FOB are start the engine, stop the engine, controlling a set RPM and controlling the E-Pump. The line of sight range for this FOB is up to 750 feet (230 m) and it measures 2.23" X 1.37" roughly.
This is the hand held transmitter that will send up to 8 signals to the receiver. The label can be customized to show what each button that is used for. The range for the transmitter is roughly 1000' (300m). The body of the transmitter measures 2" high by 1.62" wide.